DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.
NOTE:
- If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
"DTC LOGIC ".
- If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
"DTC LOGIC ".
| DTC No. |
Trouble diagnosis name |
DTC detecting condition |
Possible cause |
| B2604 |
PNP/CLUTCH SW |
The following states are detected for 5 seconds while ignition switch is ON:
- P/N position signal is sent from transmission range switch but shift position signal input (CAN) from transmission range switch is other than P (Park) and N (Neutral)
- P/N position signal is not sent from transmission range switch but shift position signal input (CAN) from transmission range switch is P (Park) or N (Neutral)
|
- Harness or connectors (CAN communication line is open or shorted)
- Harness or connectors (Transmission range switch circuit is open or shorted)
- Transmission range switch
- BCM
|