LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2013 >> Juke SL, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0445 >> DTC P0137: Ho2S2 >> Component Function Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Function Check

  1. PERFORM COMPONENT FUNCTION CHECK-I 

    Without CONSULT

    1. Start engine and warm it up to normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
    4. Let engine idle for 1 minute.
    5. Check the voltage between ECM harness connector and ground as per the following condition.
      ECM Condition Voltage
      Connector + -
      Terminal
      F25 29 33 Revving up to 4, 000 rpm under no load at least 10 times The voltage should be above 0.68 V at least once during this procedure.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

  2. PERFORM COMPONENT FUNCTION CHECK-II 

    Check the voltage between ECM harness connector and ground as per the following condition.

    ECM Condition Voltage
    Connector + -
    Terminal
    F25 29 33 Keeping engine speed at idle for 10 minutes The voltage should be above 0.68 V at least once during this procedure.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: GO TO 3.

  3. PERFORM COMPONENT FUNCTION CHECK-III 

    Check the voltage between ECM harness connector and ground as per the following condition.

    ECM Condition Voltage
    Connector + -
    Terminal
    F25 29 33 Coasting from 80 km/h (50 MPH) in D position (CVT), 4th gear position (M/T) The voltage should be above 0.68 V at least once during this procedure.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals