Component Function Check

Without CONSULT

1. Start engine and warm it up to the normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Restart engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
4. Let engine idle for 1 minute.
5. Open engine hood.
6. Check the voltage between ECM harness connector terminals as per the following condition.

   ECM			Condition	Voltage (V)
   Connector	+	-
   	Terminal
   F25	29	33	Keeping engine speed at 2500 rpm constant under no load	The voltage fluctuation cycle takes more than 5 seconds. 1 cycle: 0.6 - 1.0 → 0 - 0.3 → 0.6 - 1.0

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Proceed to "DIAGNOSIS PROCEDURE ".