VCM: Work Procedure

PERFORM VCM RECOMMUNICATING FUNCTION
1. Install VCM.
2. Contact backside of registered Intelligent key* to power switch while brake pedal is depressed, then turn power switch to the ON position.
  *: To perform this step, use the key that is used before performing VCM replacement.
3. Maintain power switch in the ON position for at least 5 seconds.
4. Turn power switch to the OFF position.
5. Check that the vehicle can be set to READY.
: GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING VCM
Perform the following procedure "REMOVAL AND INSTALLATION ".

: Inspection End.