Values On The Diagnosis Tool
WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor item | Condition | Value/Status | |
|---|---|---|---|
| VHCL SPEED SE | While driving | Value of vehicle speed signal (wheel speed) | |
| YAW RATE | While driving | Vehicle stopped | 0.0 |
| Vehicle turning right | Positive value | ||
| Vehicle turning left | Negative value | ||
| PWR SUP MONI | Ignition switch ON | Power supply voltage value of ICC sensor | |
| DISTANCE | Drive the vehicle and activate the ICC system. | When a vehicle ahead is detected | Displays the distance from the preceding vehicle |
| When a vehicle ahead is not detected | 0.0 | ||
| RELATIVE SPD | Drive the vehicle and activate the ICC system. | When a vehicle ahead is detected | Displays the relative speed |
| When a vehicle ahead is not detected | 0.0 | ||
| LASER OFFSET |
NOTE:
The item is indicated but not used. |
- | |
| LASER HEIGHT |
NOTE:
The item is indicated but not used. |
- | |
| STEERING ANGLE | Ignition switch ON | When setting the steering wheel in straight-ahead position | 0.0 |
| When turning the steering wheel 90° rightward | +90 | ||
| When turning the steering wheel 90° leftward | -90 | ||
| STRG ANGLE SPEED | Ignition switch ON | At the time of turning the steering wheel | Steering wheel turning speed is displayed |
| L/R ADJUST | Ignition switch ON | At the completion of radar alignment adjustment | Horizontal correction value is displayed |
| U/D ADJUST | Ignition switch ON | At the completion of radar alignment adjustment | Vertical correction value is displayed |
| FEB SELECT | Engine running | FCW system set with the information display is ON | ON |
| FCW system set with the information display is OFF | OFF | ||
| MAIN SW | Ignition switch ON | When MAIN switch is pressed | On |
| When MAIN switch is not pressed | Off | ||
| ICC/ASCD MODE | Engine running | Intelligent Cruise Control System MAIN switch status | On |
| Off | |||
| SET/COAST SW | Ignition switch ON | When SET/COAST switch is pressed | On |
| When SET/COAST switch is not pressed | Off | ||
| CANCEL SW | Ignition switch ON | When CANCEL switch is pressed | On |
| When CANCEL switch is not pressed | Off | ||
| RESUME/ACC SW | Ignition switch ON | When RESUME/ACC SW switch is pressed | On |
| When RESUME/ACC SW switch is not pressed | Off | ||
| DISTANCE SW | Ignition switch ON | When DISTANCE switch is pressed | On |
| When DISTANCE switch is not pressed | Off | ||
| BRAKE SW | Ignition switch ON | When brake pedal is depressed | On |
| When brake pedal is not depressed | Off | ||
| STOP LAMP SW | Ignition switch ON | When brake pedal is depressed | On |
| When brake pedal is not depressed | Off | ||
| IDLE SW | Engine running | Idling | On |
| Except idling (depress accelerator pedal) | Off | ||
| CRUISE LAMP | Start the engine and press MAIN switch | ICC system ON (MAIN switch indicator ON) |
On |
| ICC system OFF (MAIN switch indicator OFF) |
Off | ||
| VHCL AHEAD | Drive the vehicle and activate the Intelligent Cruise Control System | When a vehicle ahead is detected (vehicle ahead detection indicator ON) | On |
| When a vehicle ahead is detected (vehicle ahead detection indicator OFF) | Off | ||
| SET DISTANCE |
|
When set to "long" | LONG |
| When set to "middle" | MID | ||
| When set to "short" | SHORT | ||
| THRT SENSOR [%] |
Engine running | Depress accelerator pedal | Displays the throttle position |
| VEHICLE AHEAD DETECT | Engine running | - | - |
| STATIC OBSTACLE DETECT | Indicates [ON/Off] status of static obstacle detection | ||
| BUZZER O/P | Engine running | When the buzzer of the following system operates:
|
On |
When the buzzer of the following system does not operate:
|
Off | ||
| FUNC ITEM (FCW) | Ignition switch ON | - | - |
| FUNC ITEM (PFCW) | On | ||
| FUNC ITEM (FEB) | |||
| FUNC ITEM (ICC) | |||
| PRESS_ORDER | Engine running | - | |
| D RANGE SW | Engine running | When the selector lever is in "D" position or manual mode | On |
| When the selector lever is in any other than "D" or manual mode | Off | ||
| NP RANGE SW | Engine running | When the selector lever is in "N""P" | On |
| When the selector lever is in any other than "N""P" | Off | ||
| PKB SW | Ignition switch ON | When the parking brake is applied | On |
| When the parking brake is released | Off | ||
| VHCL SPD AT | While driving | - | Value of CVT vehicle speed sensor signal |
| Shift position |
|
- | Displays the shift position |
| SYSTEM CANCEL MESSAGE | Engine running | System cancel display OFF | NO REQ |
| System cancel reason is slippery road | SLIP | ||
| System cancel reason is VDC OFF | VDC OFF | ||
| DISP VHCL SPD UNIT | Engine running | Meter indicates km/h | km/h |
| Meter indicates mph | mph | ||
| VHCL SPD UNIT | Engine running | Meter indicates km/h | km/h |
| Meter indicates mph | mph | ||
| ADAS MALF | Engine running | ADAS is malfunction | On |
| ADAS is not malfunction | Off | ||
| STOP LAMP RELAY ON | Engine running | Stop lamp relay is fixed on | On |
| Stop lamp relay is not fixed on | Off | ||
| STOP LAMP RELAY OFF | Engine running | Stop lamp relay is fixed off | On |
| Stop lamp relay is not fixed off | Off | ||
| ICC CANCEL | NOTE: The item is indicated, but not used |
- | - |
| ACCEL COM VALUE 1 [m/s2] |
Engine running | - | ICC sensor request accel command to ADAS controller |
| ICC STATUS | Engine running | Intelligent Cruise Control System Off | Off |
| Intelligent Cruise Control System On | ICC | ||
| Intelligent Cruise Control System On and vehicle is stopped | STOP1 | ||
| Intelligent Cruise Control System On and Driver depressed accelerator pedal | ACCEL | ||
| MILEAGE | While driving | When an FEB event occurs | Displays the speed at which an FEB event occurred |