Cause Of Auto Cancel
WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
| Work support items | Description |
|---|---|
| OPERATING ABS | ABS function was operated. |
| OPERATING TCS | TCS function was operated. |
| OPERATING VDC | VDC function was operated. |
| ECM CIRCUIT | ECM did not permit ICC operation. |
| CVT CIRCUIT | CVT did not permit ICC operation. |
| RADAR BLOCKED | Stain or foreign matter on sensor body. |
| LASER TEMP | ICC sensor temperature too high. |
| OP SW VOLT CIRC | The ICC steering switch input voltage is not within standard range. |
| OP SW DOUBLE TOUCH | The ICC steering switches were pressed at the same time. |
| VHCL SPD DOWN | Vehicle speed is lower than 24 km/h (15 mph). |
| WHL SPD ELEC NOISE | Wheel speed sensor signal caught electromagnetic noise. |
| VDC/TCS OFF SW | VDC OFF switch was pressed. |
| VHCL SPD UNMATCH | Wheel speed became different from CVT vehicle speed. |
| TIRE SLIP | Wheel slipped. |
| IGN LOW VOLT | Decrease in ICC sensor ignition voltage. |
| PARKING BRAKE ON | The parking brake is operating. |
| WHEEL SPD UNMATCH | The wheel speed of all four wheels are out of the specified values. |
| INCHING LOST | a vehicle ahead is not detected during the following driving when the vehicle speed is approximately 24 km/h (15 mph) or less. |
| CAN COMM ERROR | ICC sensor received an abnormal signal with CAN communication. |
| ABS/TCS/VDC CIRC | An abnormal condition occurs in VDC/TCS/ABS system. |
| ECD CIRCUIT | An abnormal condition occurs in ECD system. |
| BCU CIRCUIT | An abnormal condition occurs in BCU system. |
| ASCD VHCL SPD DTAC | Vehicle speed is detached from the set vehicle speed. |
| ASCD DOUBLE COMD | Cancel switch and operation switch are detected simultaneously. |
| FEB OPERATED | FEB activated. |
| VHL AHAD LOST (CLSE RANGE) | A vehicle ahead lost close range. |
| ABS LAMP | ABS lamp ON. |
| NO RECORD | - |