Common Specifications & Procedures
SENTRA COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | |||
| Axle Nut/Hub Nut | ||||
| Front Axle Nut | 96 Ft. lbs. (130 N.m, 13 kg.m) | |||
| Front Hub Bolts | 65 Ft. lbs. (88.3 N.m, 9.0 kg.m) | |||
| Rear Hub Bolts | 65 Ft. lbs. (88.3 N.m, 9.0 kg.m) | |||
| Battery | BATTERY | |||
| Brakes | ||||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |||
| Disc Brakes | ||||
| Front | FRONT DISC BRAKE | |||
| Rear | REAR DISC BRAKE | |||
| Drum Brakes | REAR DRUM BRAKE | |||
| Torque | ||||
| Front | See Torque Specifications in applicable figures under FRONT DISC BRAKE . | |||
| Rear | ||||
| Rear Disc | See Torque Specifications in applicable figures under REAR DISC BRAKE . | |||
| Rear Drum | See Torque Specifications in applicable figures under REAR DRUM BRAKE . | |||
| Charging | ||||
| Generator | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | |||
| Drive Belts | ||||
| Belt Routing | DRIVE BELT | |||
| Belt Tensioning | Vehicle equipped with auto tensioner | |||
| Engine Cooling | ||||
| General Service Specifications | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Radiator Cap Pressure | 11.4-14.2 psi (78.2-97.8 kPa (0.8-1.0 kg/cm2 ) | |||
| Thermostat R & I | THERMOSTAT AND THERMOSTAT HOUSING | |||
| Water Pump R & I | WATER PUMP | |||
| Engine Mechanical | ||||
| Compression | COMPRESSION PRESSURE | |||
| Oil Pressure | ||||
| @ Idle | 10.3 psi (71 kPa.72 kg/cm2 ) or more | |||
| @ 2000 RPM | 29 psi (200 kPa, 2.04 kg/cm2 ) or more | |||
| Overhaul | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flex Plate (Drive Plate) Torque | ||||
| A/T & M/T | 80 Ft. lbs. (108 N.m) | |||
| Fuel System | ||||
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | |||
| Pressure | At idling: Approximately 51 psi (350 kPa, 3.57 kg/cm2 ) | |||
| Fuel Pressure Test Procedure | FUEL PRESSURE CHECK | |||
| Fuel Filter Location | In Tank Type | |||
| Fuel Filter R & I | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | Engine has coil-on-plug ignition. | |||
| Ignition Wires (Routing) | Engine has coil-on-plug ignition. | |||
| Spark Plugs | SPARK PLUG Tightening torque: 14 ft. lbs. (19.6 N.m) |
|||
| Starting | ||||
| Starter | STARTER MOTOR | |||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION | |||
| Wheel Alignment | ||||
| Adjustment Specifications | ||||
| Front | WHEEL ALIGNMENT (UNLADEN*1) | |||
| Rear | WHEEL ALIGNMENT (UNLADEN*1) | |||
| Torque | ||||
| Front | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | |||
| Rear | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 83 Ft. lbs. (113 N.m, 12 kg.m) | |||
| How To Use Nissan Service Information | ||||
| Includes: Standard Bolt Torque Symbol Identification General Connector Info |
GENERAL INFORMATION | |||