DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

• Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface. 
• Always perform test at a temperature of 0 to 30°C (32 to 86°F). 
  NOTE: Make sure that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

  Do you have CONSULT? 

  YES: GO TO 2.

  NO: GO TO  3.

With CONSULT 

1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
4. Make sure that the following conditions are met.

   COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

   INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.

   Follow the instruction displayed.

   NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT screen, go to "WORK PROCEDURE ".

   Which is displayed on CONSULT screen? 

   OK: INSPECTION END

   NG: Go to "DIAGNOSIS PROCEDURE ".

With GST 

1. Start engine.
2. Drive vehicle according to DRIVING PATTERN in "SRT SET DRIVING PATTERN ".
3. Stop vehicle.
4. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
5. Select Service $07 with GST.

   Is 1st trip DTC displayed? 

   YES-1: P0441: Refer to "DIAGNOSIS PROCEDURE ".

   YES-2: P0442: Refer to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END