| ITS control unit |
- Controls each system, based on signals received from the rear view camera and CAN communication signals received from each control unit
- Transmits signals necessary for control between CAN communication
|
| Blind Spot Warning indicator LH/RH |
Receives Blind Spot Warning indicator operation signal from rear view camera and turns OFF, turns ON or blinks |
| Warning systems switch |
Inputs the switch signal to ITS control unit |
| Warning systems ON indicator (On the warning systems switch) |
Indicates BSW/LDW system status |
| Rear view camera |
- Detects the lane marker by the built-in camera
- Transmits detected lane condition signal to ITS control unit
|
| ABS actuator and electric unit (control unit) |
- Transmits vehicle speed signal to ITS control unit via CAN communication
- Transmits yaw rate signal/side G sensor signal to ITS control unit via CAN communication
|
| Buzzer (combination meter) |
Receives buzzer signal from ITS control unit and sounds buzzer. |
| Combination meter |
- Turns the Lane Departure Warning/Blind Spot Warning indicator ON/OFF according to the signals from the ITS control unit via CAN communication
- Receives Lane Departure Warning/Blind Spot Warning ON indicator signal via CAN communication.
|
| Steering angle sensor |
Transmits steering angle sensor signal to ITS control unit via CAN communication |
| BCM |
- Transmits turn signal indicator to ITS control unit via CAN communication
- Transmits dimmer signal to ITS control unit via CAN communication
|
| ECM |
Transmits engine speed signal to ITS control unit via CAN communication |
| TCM |
Transmits the output shaft speed signal, input speed signal, current gear position signal and shift position signal to ITS control unit via CAN communication |
| AV control unit (with navigation system and bose audio system) |
Receives the various systems and camera signals via CAN communication and routes them to the center display |
| Audio unit (with display audio system and bose audio system) |
Receives the various systems and camera signals and routes them to the center display |
| Center display |
Displays the various system screen signals according to the priority level received via CAN communication |
| Rear view camera washer control unit |
Controls the air pump to drive air to the rear camera lens according to the signals received from the ITS control unit |
| Rear view camera air pump motor |
Drives air to the rear camera lens according to the signals received from the pump control unit |