LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2014 >> Cube SL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control System (Without Intelligent Key) >> Basic Inspection >> Additional Service When Replacing Control Unit >> Work Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure

  1. SAVING VEHICLE SPECIFICATION 

    CONSULT Configuration

    Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to "DESCRIPTION ".

    NOTE: If "READ CONFIGURATION" cannot be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.

    : GO TO 2.

  2. REPLACE BCM 

    Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

    : GO TO 3.

  3. WRITING VEHICLE SPECIFICATION 

    CONSULT Configuration

    Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to "WORK PROCEDURE ".

    : GO TO 4.

  4. INITIALIZE BCM (NATS) (IF EQUIPPED) 

    Perform BCM initialization. (NATS)

    : GO TO 5.

  5. KEYFOB ID REGISTRATION (IF EQUIPPED) 

    Perform keyfob ID registration. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: DESCRIPTION ".

    : WORK END

scientia non olet · About LEMON Manuals