Fail-Safe Control By DTC
WARNING: This page is about a different car, the 2013 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
BCM performs fail-safe control when any DTC are detected.
| Display contents of CONSULT | Fail-safe | Cancellation | ||
|---|---|---|---|---|
| B2192: ID DISCORD BCM-ECM(1) | Inhibit setting the vehicle to READY | Erase DTC | ||
| B2193: CHAIN OF BCM-ECM(1) | Inhibit setting the vehicle to READY | Erase DTC | ||
| B2195: ANTI-SCANNING | Inhibit setting the vehicle to READY | Power switch ON → OFF | ||
| B2196: DONGLE NG | Inhibit setting the vehicle to READY | Erase DTC | ||
| B2198: IMMOBI ANT NG | Inhibit setting the vehicle to READY | Erase DTC | ||
| B261E: FUEL MIS CONFIG | Inhibit setting the vehicle to READY | When the VCM status signal is normally received from VCM. | ||
| B26F1: IGN RELAY OFF STUCK | Inhibit setting the vehicle to READY | When the following conditions are fulfilled
|
||
| B26F2: IGN RELAY ON STUCK | Inhibit setting the vehicle to READY | When the following conditions are fulfilled
|
||
| B26F7: LF DRIVER COMMUNICATION | Inhibit setting the vehicle to READY | When inside key antennas function normally | ||
| U0415: VDC CAN CIRC2 | Inhibit setting the vehicle to READY | When vehicle speed signal (Meter) (CAN) is received normally | ||
|
||||