LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2014 >> Maxima SV >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0196 To P0607 >> DTC P0456: EVAP Control System >> DTC Logic >> DTC Detection Logic
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Detection Logic

NOTE: If DTC P0456 is displayed with DTC P0442, first perform the trouble diagnosis for DTC P0456.

This diagnosis detects very small leakage in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the intake manifold vacuum in the same way as conventional EVAP small leakage diagnosis.

If ECM judges a leakage which corresponds to a very small leakage, the very small leakage P0456 will be detected.

If ECM judges a leakage equivalent to a small leakage, EVAP small leakage P0442 will be detected.

If ECM judges that there are no leakage, the diagnosis will be OK.

Fig 1: EVAP Control - System Diagram
G05700599Courtesy of NISSAN NORTH AMERICA, INC.
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0456 Evaporative emission control system very small leakage (negative pressure check)
  • EVAP system has a very small leakage.
  • EVAP system does not operate properly.
  • Incorrect fuel tank vacuum relief valve
  • Incorrect fuel filler cap used
  • Fuel filler cap remains open or fails to close.
  • Foreign matter caught in fuel filler cap.
  • Leakage is in line between intake manifold and EVAP canister purge volume control solenoid valve.
  • Foreign matter caught in EVAP canister vent control valve.
  • EVAP canister or fuel tank leakage
  • EVAP purge line (pipe and rubber tube) leakage
  • EVAP purge line rubber tube bent
  • Loose or disconnected rubber tube
  • EVAP canister vent control valve and the circuit
  • EVAP canister purge volume control solenoid valve and the circuit
  • Fuel tank temperature sensor
  • Drain filter
  • O-ring of EVAP canister vent control valve is missing or damaged
  • EVAP canister is saturated with water
  • EVAP control system pressure sensor
  • Refueling EVAP vapor cut valve
  • ORVR system leakage
  • Fuel level sensor and the circuit
  • Foreign matter caught in EVAP canister purge volume control solenoid valve
CAUTION:
  • Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may illuminate.
  • If the fuel filler cap is not tightened properly, the MIL may illuminate.
  • Use only a genuine NISSAN rubber tube as a replacement.