LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2014 >> Rogue Select AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Diagnostic Codes & Symptom Tests) >> DTC/Circuit Diagnosis >> DTC P0453: EVAP Control System Pressure Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR 
    1. Turn ignition switch OFF.
    2. Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister. Refer to "REMOVAL AND INSTALLATION ".

      Always replace O-ring with a new one. 

    3. Install a vacuum pump to EVAP control system pressure sensor.
    4. Turn ignition switch ON and check output voltage between ECM harness connector terminals under the following conditions.
      ECM Condition [Applied vacuum kPa (kg/cm2 , psi)] Voltage (V)
      Connector Terminal
      + -
      E16 86 (EVAP control system pressure sensor signal) 96 (Sensor ground) Not applied 1.8 - 4.8
      -26.7 (-0.272, -3.87) 2.1 to 2.5 lower than above value
      CAUTION:
      • Always calibrate the vacuum pump gauge when using it.
      • Never apply below -93.3 kPa (-0.952 kg/cm2 , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2 , 14.69 psi).

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace EVAP control system pressure sensor. Refer to "REMOVAL AND INSTALLATION ".

scientia non olet · About LEMON Manuals