LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2014 >> Rogue Select AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Security Control System (With Intelligent Key)) >> DTC/Circuit Diagnosis >> DTC B2604: Shift Position >> DTC Logic >> DTC Detection Logic
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Detection Logic

WARNING: This page is about a different car, the 2014 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to "DTC LOGIC ".
  • If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to "DTC LOGIC ".
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B2604 SHIFT PN DIAG CAN The following states are detected for 5 seconds while ignition switch is ON.
  • P/N position signal is sent from transmission range switch but shift position signal input (CAN) from TCM is other than P and N
  • P/N position signal is not sent from transmission range switch but shift position signal input (CAN) from TCM is P or N
  • Harness or connectors (The CAN communication line is open or shorted.)
  • Harness or connectors (Transmission range switch circuit is open or shorted.)
  • TCM
  • BCM
scientia non olet · About LEMON Manuals