DTC Confirmation Procedure
WARNING: This page is about a different car, the 2014 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM DTC CONFIRMATION PROCEDURE
- Press push-button ignition switch under the following conditions to start engine.
- Selector lever: In the P position
- Brake pedal: Not depressed
- Wait 2 seconds after engine started.
- Check DTC in Self Diagnostic Result mode of BCM using CONSULT.
Is DTC detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: Inspection End.
- Press push-button ignition switch under the following conditions to start engine.