Values On The Diagnosis Tool
WARNING: This page is about a different car, the 2014 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The output signal indicates the EPS control unit calculation data. The normal values will be displayed even in the event that the output circuit (harness) is open.
| Monitor item |
Data monitor |
| Condition |
Display value |
| BATTERY VOLT |
Ignition switch: ON |
Battery voltage |
| TORQUE SENSOR |
Engine running |
Steering wheel: Not steering (There is no steering force) |
Approx. 0 Nm |
| Steering wheel: Right turn |
Positive value (Nm) |
| Steering wheel: Left turn |
Negative value (Nm) |
| MOTOR CURRENT |
Engine running |
Steering wheel: Not steering (There is no steering force) |
Approx. 0 A |
| Steering wheel: Right or left turn |
Displays consumption current of EPS motor (A) |
| MOTOR SIG |
Engine running |
Steering wheel: Not steering (There is no steering force) |
Approx. 0 A |
| Steering wheel: Right turn |
Positive value (A) |
| Steering wheel: Left turn |
Negative value (A) |
| ASSIST TORQUE |
Engine running |
Approx. 0 Nm |
| C/U TEMP |
Ignition switch ON or engine running |
Displays temperature of inside of EPS control unit (°C or °F) |
| ASSIST LEVEL |
Engine running |
100 % |
| VEHICLE SPEED |
Vehicle stopped |
0 km/h or mph |
| While driving |
Approximately equal to the indication on speedometer
(inside of ±10%) |
| WARNING LAMP |
EPS warning lamp: ON |
On |
| EPS warning lamp: OFF |
Off |
| ENGINE STATUS |
Engine not running |
Stop |
| Engine running |
Run |