DTC Detection Logic

WARNING: This page is about a different car, the 2014 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If DTC B210E is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to "DTC LOGIC ".
If DTC B210E is displayed with DTC B2605, first perform the trouble diagnosis for DTC B2605. Refer to "DTC LOGIC ".
When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210F may be detected.

DTC No.	Trouble diagnosis name	DTC detecting condition	Possible cause
B210E	STARTER RELAY OFF	When comparing the following items, IPDM E/R detects that starter relay is stuck in the OFF position for 1 second or more. Starter control relay signal (CAN) from BCM Starter relay status signal (CAN) from BCM Starter control relay and starter relay status signal (IPDM E/R input) Starter control relay control signal (IPDM E/R output) Transmission range switch signal input	Harness or connectors (The CAN communication line is open or shorted.) Harness or connector (Starter relay circuit is open or shorted.) IPDM E/R Battery BCM Starter relay