Diagnosis Procedure (M/T Models)

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK DTC OF BCM 

   Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT.

   Is DTC detected? 

   YES: Perform the trouble diagnosis related to the detected DTC. Refer to "DTC INDEX ".

   NO: GO TO 2.

2. CHECK CLUTCH INTERLOCK SWITCH SIGNAL CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect clutch interlock switch connector.
   3. Disconnect IPDM E/R connector.
   4. Check continuity between clutch interlock switch harness connector and IPDM E/R harness connector.

      Clutch interlock switch		IPDM E/R		Continuity
      Connector	Terminal	Connector	Terminal
      E34	2	E43	4	Yes

   5. Check continuity between clutch interlock switch harness connector and ground.

      Clutch interlock switch		Ground	Continuity
      Connector	Terminal
      E34	2		No

      Is the inspection result normal? 

      YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.