Component Function Check
- PERFORM COMPONENT FUNCTION CHECK
- Lift up drive wheels.
- Start engine (VDC switch OFF) and warm it up to normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and wait at least 70 seconds.
- Set voltmeter probes to ECM harness connector terminals as per the following.
ECM Connector + - Terminal E16 114 124 *1: Except for California
*2: For California - Check EVAP control system pressure sensor value at idle speed and note it.
- Establish and maintain the following conditions for at least 1 minute.
Air conditioner switch ON Headlamp switch ON Rear window defogger switch ON Engine speed Approx. 3, 000 rpm Gear position Any position other than P, N or R - Verify that EVAP control system pressure sensor value stays 0.1 V less than the value at idle speed (measured at step 6) for at least 1 second.
Is the inspection result normal?
YES: INSPECTION END
NO: Proceed to "DIAGNOSIS PROCEDURE ".