Component Function Check

With CONSULT 

1. Turn ignition switch ON.
2. Select "ENGINE" using CONSULT.
3. Select "CLUTCH P/P SW in "DATA MONITOR" mode.
4. Check "CLUTCH P/P SW indication under the following conditions.

   Monitor item	Condition		Indication
   CLUTCH P/P SW	Clutch pedal	Fully released	OFF
   		Fully depressed	ON

Without CONSULT 

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground.

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   E16	92 (Clutch pedal position switch signal)	E16	108	Clutch pedal	Fully released	Approx. 0V
   					Fully depressed	Battery voltage

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".