Sleep Mode Activation
- BCM receives the sleep-ready signal (ready) from IPDM E/R and combination meter via CAN communication.
- BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.
- Each unit stops the transmission of CAN communication with the sleep wake-up signal. BCM is in CAN communication sleep mode.
- BCM is in the low power consumption mode and performs the low power consumption control when all of the BCM sleep conditions are fulfilled with CAN sleep condition.
SLEEP CONDITION DESCRIPTION
| CAN sleep condition |
BCM sleep condition |
- Receiving the sleep-ready signal (ready) from all units
- Ignition switch: OFF
- Vehicle security system alarm: No operation
- Warning lamp: Not operation
- Stop lamp switch: OFF
- Turn signal indicator lamp: No operation
- Exterior lamp: OFF
- Door lock status: No change
- CONSULT communication status: No communication
- Door switch status: No change
- Rear window defogger: OFF
- Driver door lock status: No change
- Key switch status: No change
|
- Interior room lamp battery saver: Time out
- RAP system: OFF
- Nissan Vehicle Immobilizer System (NVIS) - NATS: No operation
- Remote keyless entry receiver communication status: No communication
|