Component Function Check

TESTING CONDITION: 

• Before performing the following procedure, confirm that battery voltage is more than 12.8V at idle. 
• Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF. 

  : GO TO 2.

With CONSULT 

1. Start engine and let it idle.
2. Select "BAT CUR SEN" in "DATA MONITOR" mode with CONSULT.
3. Check "BAT CUR SEN" indication for 10 seconds.

   "BAT CUR SEN" should be above 2, 300mV at least once. 

Without CONSULT 

1. Start engine and let it idle.
2. Check the voltage between ECM harness connector and ground.

   ECM		Ground	Voltage
   Connector	Terminal
   F11	58 (Battery current sensor signal)	Ground	Above 2.3V at least once

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".