DTC Detection Logic

NOTE:

If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC LOGIC .
If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC LOGIC .

DTC No.	Trouble diagnosis name	DTC detecting condition	Possible cause
B2604	PNP/CLUTCH SW	The following states are detected for 5 seconds while ignition switch is ON: P/N position signal is sent from IPDM E/R but shift position signal input from transmission range switch is other than P (Park) and N (Neutral). P/N position signal is not sent from IPDM E/R but shift position signal input from transmission range switch is P (Park) or N (Neutral).	Harness or connectors (CAN communication line is open or shorted.) Harness or connectors (transmission range switch circuit is open or shorted.) Transmission range switch BCM