Operation And Display Of ACCS (Advanced Climate Control System)
DISPLAY: DISPLAY IN FRONT A/C CONTROL
Plasmacluster™ ion
- Plasmacluster™ ion control state is indicated on display in front A/C control.
- Plasmacluster™
ion control state is switched as shown in the figure below depending on air flow.
- When air flow is small
- When air flow is large
Automatic Intake Control (Exhaust Gas/Outside Odor Detecting Mechanism)
- When the AUTO intake switch is turned ON, ambient atmosphere status is indicated on the display in the front A/C control, while the exhaust gas/outside odor detecting sensor detects exhaust gas or unpleasant odor.
NOTE:
- After the ignition switch is turned ON, warm up the exhaust gas/outside odor detecting sensor for approximately 40 seconds.
- When the AUTO intake switch is turned ON, the ambient atmosphere status is displayed continuously until sensor warm up is completed.
OPERATION: FRONT A/C CONTROL
| 1. | Intake Switch | 2. | Temperature Control Switch (Driver Side) | 3. | MODE Switch |
| 4. | ON•OFF Switch | 5. | AUTO Switch | 6. | Fan Switch |
| 7. | A/C Switch | 8. | REAR Switch | 9. | DUAL Switch |
| 10. | Temperature Control Switch (Passenger Side) | 11. | DEF Switch | 12. | Display |
| 13. | AUTO Intake Switch |
| Switch Name | Function |
|---|---|
| AUTO intake switch |
NOTE:
|
NOTE:
The following switches are not necessary for ACCS (Advanced Climate Control System) operation.
| Intake switch | Refer to SWITCH NAME AND FUNCTION . |
| Temperature control switch (driver side) | |
| MODE switch | |
| ON•OFF switch | |
| AUTO switch | |
| Fan switch | |
| A/C switch | |
| DUAL switch | |
| Temperature control switch (passenger side) | |
| DEF switch | |
| REAR switch | Refer to SWITCH NAME AND FUNCTION . |