LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2015 >> Rogue SL, FWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Airbag Control System >> Basic Inspection >> Inspection And Adjustment >> Configuration >> Work Procedure >> Configuration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure: Configuration

Vehicle specification needs to be written with CONSULT because it is not written after replacing air bag diagnosis sensor unit.

Configuration has three functions as follows:

Function Description
"Before Replace ECU"
  • Reads the vehicle configuration of current air bag diagnosis sensor unit.
  • Saves the read vehicle configuration.
"After Replace ECU" Writes the vehicle configuration with manual selection.
"Select Saved Data List" Writes the vehicle configuration with saved data.
CAUTION:
  • When replacing air bag diagnosis sensor unit, you must perform "Select Saved Data List" or "After Replace ECU" with CONSULT.
  • Complete the procedure of "Select Saved Data List" or "After Replace ECU" in order.
  • If you set incorrect "Select Saved Data List" or "After Replace ECU", incidents might occur.
  • Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
  • Never perform "Select Saved Data List" or "After Replace ECU" except for new air bag diagnosis sensor unit.

  1. SAVING VEHICLE SPECIFICATION

    G-20 CONSULT

    Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

    NOTE:

    If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

    GO TO STEP 2  .

  2. REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

    Replace air bag diagnosis sensor unit. Refer to REMOVAL AND INSTALLATION .

    GO TO STEP 3  .

  3. WRITING VEHICLE SPECIFICATION

    G-20 CONSULT

    1. Enter "Re/Programming, Configuration".
    2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification.
    3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification.
      1. Select "After Replace ECU" or "Manual Configuration".
      2. Identify the correct model and configuration list.
      3. Confirm and/or change setting value for each item.
        CAUTION:

        Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.

      4. Select "Next".
        CAUTION:

        Make sure to select "Next", confirm each setting value and press "OK" even if the indicated configuration of brand new air bag diagnosis sensor unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized.

      5. When "Completed", select "End".

    GO TO STEP 4  .

  4. OPERATION CHECK

    Confirm that each function controlled by air bag diagnosis sensor unit.

    Work End.

scientia non olet · About LEMON Manuals