LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2015 >> Rogue Select AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Diagnostic Trouble Codes (DTCS) P0130-P1225) >> DTC/Circuit Diagnosis >> DTC P0340: CMP Sensor (Phase) >> DTC Logic >> DTC Detection Logic
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Detection Logic

NOTE:

If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to  DTC LOGIC  . 

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0340 Camshaft position sensor (PHASE) circuit
  • The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking.
  • The cylinder No. signal is not sent to ECM during engine running.
  • The cylinder No. signal is not in the normal pattern during engine running.
  • Harness or connectors

    (The sensor circuit is open or shorted)

  • Camshaft position sensor (PHASE)
  • Camshaft (INT)
  • Starter motor (Refer to SYSTEM DIAGRAM .)
  • Starting system circuit (Refer to SYSTEM DIAGRAM .)
  • Dead (Weak) battery
scientia non olet · About LEMON Manuals