DTC Confirmation Procedure
Never refuel before and during the following procedure.
- PRECONDITIONING-I
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO STEP 2 .
- PRECONDITIONING-II
With CONSULT
- Turn ignition switch ON.
- Check the following conditions:
Ambient temperature - 10°C (14°F) or more A/C switch OFF Blower fan switch OFF - Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
- Check the following conditions:
COOLAN TEMP/S - 10°C -46°C (14-114°F)
Is the condition satisfied?
YES
GO TO STEP 3 .
NO
- Satisfy the condition.
- GO TO STEP 3 .
- PERFORM DTC CONFIRMATION PROCEDURE-I
With CONSULT
- Start engine.
- Drive the vehicle until the following condition is satisfied.CAUTION:
Always drive vehicle at safe speed.
- STEP 1
Drive the vehicle under the conditions instructed below until the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" becomes at least 24°C (75°F).
COOLAN TEMP/S 65°C (149°F) or less FUEL T/TMP SE Less than the value calculated by subtracting 24°C (75°F) from "COOLAN TEMP/S".* *: EXAMPLECOOLAN TEMP/S FUEL T/TMP SE 70°C (158°F) 45°C (113°F) or less 65°C (149°F) 40°C (104°F) or less 60°C (140°F) 35°C (95°F) or less - STEP 2
Drive the vehicle at 50 km/h (32 MPH) or more with the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" maintained at 24°C (75°F) or more.
NOTE:Keep the accelerator pedal as steady as possible during cruising.
- STEP 3
Drive the vehicle at 50 km/h (32 MPH) or more until "COOLAN TEMP/S" increases by 6°C (43°F).
NOTE:Keep the accelerator pedal as steady as possible during cruising.
- STEP 1
Is the condition satisfied?
YES
GO TO STEP 4 .
NO
GO TO STEP 1 .
- PERFORM DTC CONFIRMATION PROCEDURE-II
With CONSULT
- Drive the vehicle until the following condition is satisfied.
COOLAN TEMP/S 65°C (149°F) or more CAUTION:Always drive vehicle at safe speed.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO
INSPECTION END
- Drive the vehicle until the following condition is satisfied.