Diagnostic Test
- SAVING VEHICLE SPECIFICATION
- CONSULT
Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.
NOTE:If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing AV control unit.
GO TO STEP 2 .
- REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 3 .
- WRITING VEHICLE SPECIFICATION
- Enter "Re/Programming, Configuration".
- If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to WORK PROCEDURE .
- If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to WORK PROCEDURE .
GO TO STEP 4 .
- REGISTER AV CONTROL UNIT
Perform AV control unit registration. Refer to WORK PROCEDURE .
GO TO STEP 5 .
- OPERATION CHECK
Check that the operation of the AV control unit and camera images (fixed guide lines) are normal.
Work End.