| Destination cannot be set. |
Destination to be set is on an expressway. |
Set the destination on an ordinary road. |
| Passing point is not searched when re - searching the route. |
The vehicle has already passed the passing point, or the system judged so. |
To include the passing points that have been passed into the route again, set the route again. |
| Route information will not be displayed. |
Route searching has not been done. |
Set the destination and perform route searching. |
| Vehicle mark is not on the recommended route. |
Drive on the recommended route. |
| Route guide is turned OFF. |
Turn route guide ON. |
| Route information is not available on the dark pink route. |
System is not malfunctioning. |
| After the route searching, no guide sign will appear as the vehicle goes near the entrance/exit to the toll road. |
Vehicle mark is not on the recommended route. (On the display, only guide signs related to the recommended route will be shown.) |
Drive on the recommended route. |
| Automatic route searching is not possible. |
Vehicle is driving on a highway (gray route), or no recommended route is available. |
Drive on a road to be searched. Or re-search the route manually. In this case, however, the whole route will be searched. |
| Performed automatic detour search (or detour search). However, the result is the same as that of the previous search. |
Performed search with every conditions considered. However, the result is the same as that of the previous search. |
System is not malfunctioning. |
| Passing points cannot be set. |
More than five passing points were set. |
Passing points can be set up to five. To stop at more than five points, perform sharing in several steps. |
| When setting the route, the starting point cannot be selected. |
The current vehicle location is always set as the starting point of a route. |
System is not malfunctioning. |
| Some menu items cannot be selected. |
The vehicle is being driven. |
Stop the vehicle at a safe place and then operate the system. |