Diagnostic Test

With CONSULT 

1. Turn ignition switch ON.
2. Select "CPP SW" and "CLUTCH INTLCK SW" in "DATA MONITOR" mode with CONSULT.
3. Check "CPP SW" and "CLUTCH INTLCK SW" indication under the following conditions.

   Monitor item	Condition		Indication
   CPP SW	Clutch pedal	Fully released	ON
   		Fully depressed	OFF
   CLUTCH INTLCK SW		Fully released	OFF
   		Fully depressed	ON

Without CONSULT 

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM				Condition		Voltage (V)
   +		-
   Connector	Terminal	Connector	Terminal
   F101	41 (Clutch pedal position switch signal)	M107	128	Clutch pedal	Fully released	Approx. 0
   					Fully depressed	Battery voltage
   	42 (Clutch interlock switch signal)				Fully released	Approx. 0
   					Fully depressed	Battery voltage

Is the inspection result normal?

YES 

INSPECTION END

NO 

Go to DIAGNOSIS PROCEDURE .