Diagnostic Test

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform DESCRIPTION .
4. Turn ignition switch ON.
5. Set selector lever to D (A/T) or 1st (M/T) position.
6. Check the voltage between ECM harness connector terminals as per the following.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F101	30 [TP sensor 1 (bank 1) ]	40	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	31 [TP sensor 1 (bank 2) ]	48		Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	34 [TP sensor 2 (bank 1) ]	40		Fully released	Less than 4.75
   				Fully depressed	More than 0.36
   	35 [TP sensor 2 (bank 2) ]	48		Fully released	Less than 4.75
   				Fully depressed	More than 0.36

Is the inspection result normal?

YES 

INSPECTION END

NO 

GO TO STEP 2  .

Replace malfunctioning electric throttle control actuator. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .

INSPECTION END