Sleep Mode Activation
WARNING: This page is about a different car, the 2017 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- BCM receives the sleep-ready signal (ready) from IPDM E/R and combination meter via CAN communication.
- BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.
- Each unit stops the transmission of CAN communication with the sleep wakeup signal. BCM is in CAN communication sleep mode.
- BCM is in the low power consumption mode and performs the low power consumption control when all of the BCM sleep conditions are fulfilled with CAN sleep condition.
SLEEP CONDITION
| CAN sleep condition |
BCM sleep condition |
- Receiving the sleep-ready signal (ready) from all units
- Ignition switch: OFF
- Vehicle security system alarm and panic alarm : No operation
- Warning lamp: Not operation
- Intelligent Key system buzzer: No operation
- Brake switch: OFF
- Turn signal indicator lamp: No operation
- Exterior lamp: OFF
- Door lock status: No change
- CONSULT communication status: No communication
- Meter display signal : Non-transmission
- Door switch status: No change
- Rear window defogger: OFF
|
- Interior room lamp battery saver: Time out
- RAP system: OFF
- Power window switch communication: No transmission
- Push-button ignition switch (push switch) illumination: OFF
- NATS: No operation
- Remote keyless entry receiver communication status: No communication
- Tire pressure monitoring system: Stop
|