Detailed Flow
- INTERVIEW AND SYMPTOM CONFIRMATION
Check the malfunction symptoms by performing the following items:
- Interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred).
- Check the symptom.
Is the occurred symptom a malfunction?
YES
GO TO STEP 2 .
NO
Inspection End.
- DIAGNOSIS WITH CONSULT
- Connect CONSULT and perform a "Self Diagnostic Result" for "MULTI AV". Refer to CONSULT FUNCTION .NOTE:
Skip to step 4 of the diagnosis procedure if "MULTI AV" is not displayed.
- When DTC is detected, follow the instructions below:
- Record DTC and Freeze Frame Data (FFD).
Is DTC displayed?
YES
GO TO STEP 3 .
NO
GO TO STEP 4 .
- Connect CONSULT and perform a "Self Diagnostic Result" for "MULTI AV". Refer to CONSULT FUNCTION .
- TROUBLE DIAGNOSIS FOR DTC
- Check the DTC indicated in the "Self Diagnostic Result".
- Perform the relevant diagnosis referring to the DTC Index. Refer to CONSULT FUNCTION .
GO TO STEP 5 .
- TROUBLE DIAGNOSIS FOR SYMPTOMS
Perform the relevant diagnosis referring to the diagnosis chart by symptom. Refer to SYMPTOM TABLE .
GO TO STEP 5 .
- ERROR PART REPAIR
- Repair or replace the identified malfunctioning parts.
- Perform a "Self Diagnostic Result" for "MULTI AV" with CONSULT.NOTE:
Erase the stored self-diagnosis results after repairing or replacing the relevant components if any DTC has been indicated in the "Self Diagnostic Result".
- Check that the symptom does not occur.
Does the symptom occur?
YES
GO TO STEP 1 .
NO
Inspection End.