DTC Description
WARNING: This page is about a different car, the 2015 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
|---|---|---|---|
| U1010 | CONTROL UNIT (CAN) [Control unit (CAN)] |
Diagnosis condition | When Ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | If Side radar RH detects malfunction by CAN controller initial diagnosis | ||
| Diagnosis delay time | - | ||
POSSIBLE CAUSE
Side radar RH
FAIL-SAFE
The following systems are canceled:
- Blind Spot Warning (BSW)
- Rear Cross Traffic Alert (RCTA)
DTC CONFIRMATION PROCEDURE
- PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
- Start the engine.
- Turn the Blind Spot Warning system ON.
- Perform "All DTC Reading" mode.
- Check if "U1010" is detected as the current malfunction in "Self Diagnostic Result" mode of "SIDE RADAR RIGHT".
Is "U1010" detected?
YES
Refer to DIAGNOSIS PROCEDURE .
NO - 1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO - 2
Confirmation after repair: Inspection End.