Diagnosis Procedure (M/T Models)

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK DTC OF BCM
   
   

   Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT.

   Is DTC detected?

   YES 

   Perform the trouble diagnosis related to the detected DTC. Refer to DTC INDEX .

   NO 

   GO TO STEP 2  .

2. CHECK CLUTCH INTERLOCK SWITCH SIGNAl CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect clutch interlock switch connector.
   3. Disconnect IPDM E/R connector.
   4. Check continuity between clutch interlock switch harness connector and IPDM E/R harness connector.

      Clutch interlock switch		IPDM E/R		Continuity
      Connector	Terminal	Connector	Terminal
      E34	2	E43	4	Yes

   5. Check continuity between clutch interlock switch harness connector and ground.

      Clutch interlock switch		Ground	Continuity
      Connector	Terminal
      E34	2		No

   Is the inspection result normal?

   YES 

   Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness.