LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra FE+S >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (3 Of 3) >> DTC/Circuit Diagnosis >> Brake Pedal Position Switch >> Component Function Check >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK BRAKE PEDAL POSITION SWITCH FUNCTION

    G-20 With CONSULT

    1. Turn ignition switch ON.
    2. Select "ENGINE" using CONSULT.
    3. Select "BRAKE SW1" in "DATA MONITOR" mode.
    4. Check "BRAKE SW1" indication under the following conditions.
      Monitor item Condition Indication
      BRAKE SW1 Brake pedal Slightly depressed OFF
      Fully released ON

    G-21 Without CONSULT

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals under the following conditions.
      ECM Condition Voltage
      (Approx.)
      Connector + -
      Terminal Terminal
      E16 116 127 Brake pedal Slightly depressed 0 V
      Fully released Battery voltage

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

scientia non olet · About LEMON Manuals