LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra FE+S >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (3 Of 3) >> DTC/Circuit Diagnosis >> DTC P2014, P2016, P2017, P2018: Intake Manifold Runner Control Valve Position Sensor >> DTC Logic >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is more than 11 V at idle. 

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start engine and let it idle for 10 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals