LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra FE+S >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (3 Of 3) >> DTC/Circuit Diagnosis >> DTC P2127, P2128: App Sensor >> Component Inspection (App Sensor) >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK ACCELERATOR PEDAL POSITION SENSOR

    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Turn ignition switch ON.
    4. Check the voltage between ECM harness connector terminals as per the following condition.
      ECM Condition Voltage
      Connector + -
      Terminal
      E16 126 127 Accelerator pedal Fully released 0.6 - 0.9 V
      Fully depressed 3.9 - 4.7 V
      119 120 Fully released 0.3 - 0.6 V
      Fully depressed 1.95 - 2.4 V

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace accelerator pedal assembly. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals