LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra FE+S >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Security Control System (With Intelligent Key System) (DTCS)) >> DTC/Circuit Diagnosis >> DTC B2110: Shift Position/Clutch Interlock Switch >> Diagnosis Procedure (CVT Models)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure (CVT Models)

WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

  1. CHECK DTC OF BCM

    Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

    Is DTC detected?

    YES 

    Perform the trouble diagnosis related to the detected DTC. Refer to DTC INDEX .

    NO 

    GO TO STEP 2  .

  2. CHECK IPDM E/R SIGNAl CIRCUIT OPEN AND SHORT

    1. Turn ignition switch OFF.
    2. Disconnect IPDM E/R connector.
    3. Disconnect transmission range switch connector.
    4. Check continuity between IPDM E/R harness connector and transmission range switch harness connector.
      IPDM E/R Transmission range switch Continuity
      Connector Terminal Connector Terminal
      E43 14 F26 7 Yes
    5. Check continuity between IPDM E/R harness connector and ground.
      (+) (-) Continuity
      IPDM E/R
      Connector Terminal
      E43 14 Ground No

    Is the inspection result normal?

    YES 

    Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

    NO 

    Repair or replace harness.

scientia non olet · About LEMON Manuals