LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra S, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Security Control System (Without Intelligent Key System)) >> System Description >> System >> Vehicle Security System >> System Description >> Operation Flow
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Operation Flow

WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
G06936224Courtesy of NISSAN NORTH AMERICA, INC.
No. System state Switching condition
1 DISARMED to PRE-ARMED When all conditions of A and one condition of B is satisfied. A B
  • Ignition switch: OFF
  • All doors: Closed
All doors are locked by:
  • Door key cylinder LOCK switch
  • LOCK button of Keyfob
  • Door lock and unlock switch
2 PRE-ARMED to ARMED When all of the following conditions are satisfied for 30 seconds.
  • Ignition switch: OFF
  • All doors: Locked
3 ARMED to ALARM When all conditions of A and B are satisfied. A B
Keyfob: Not used
  • Any door: Open
4 DISARMED to PRE-RESET No conditions.  
5 PRE-ARMED to PRE-RESET
6 ARMED to PRE-RESET
7 ALARM to PRE-RESET
8 PRE-RESET to DISARMED
9 PRE-RESET to PRE-ARMED
10 PRE-ARMED to DISARMED When one of the following condition is satisfied.
  • Ignition switch: ACC/ON
  • Door key cylinder UNLOCK switch: ON
  • UNLOCK button of Keyfob: ON
  • UNLOCK switch of door lock and unlock switch: ON
  • Any door: Open
11 ARMED to
DISARMED
When one of the following condition is satisfied.
  • Ignition switch: ACC/ON
  • Door key cylinder UNLOCK switch: ON
  • UNLOCK button of Keyfob: ON
12 ALARM to
DISARMED
13 RE-ALARM When the following condition is satisfied after the ALARM operation is finished.
  • Any door: Open
NOTE:
  • BCM ignores the door key cylinder UNLOCK switch signal input for 1 second after the door key cylinder LOCK switch signal input.
  • To lock/unlock all doors by operating remote controller button of Keyfob, the Keyfob must be within the detection area of remote keyless entry receiver. For details, refer to SYSTEM DESCRIPTION .