LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra SL >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Sensor ID Registration Using CONSULT Only
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor ID Registration Using CONSULT Only

  1. With the ignition switch in OFF position, connect scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Using CONSULT, select WORK SUPPORT in AIR PRESSURE MONITOR. Then, select ID REGIST.
  3. Select START on ID REGIST screen.
  4. Set the tire pressure of each wheel to the specification shown in the Sensor ID Registration Tire Pressure Specifications  table. Then drive the vehicle at 25 mph (40 km/h) or above for more than 3 minutes.
    Sensor ID Registration Tire Pressure Specifications

    Tire Position Tire Pressure - psi (kPa)
    Front Left 35 (240)
    Front Right 32 (220)
    Rear Right 29 (200)
    Rear Left 26 (180)
  5. After completing all ID registrations, press END on the CONSULT to complete the procedure.
  6. Inflate all tires to specification.
  7. Test drive the vehicle to ensure that the TPMS lamp is OFF and no warning messages are present.
scientia non olet · About LEMON Manuals