LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Versa Note S, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (3 Of 3) >> DTC/Circuit Diagnosis >> DTC P1217: Engine Over Temperature >> Component Function Check >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. PERFORM COMPONENT FUNCTION CHECK-I

    WARNING:

    Never remove the radiator cap when the engine is hot. Serious burns could be caused by high pressure fluid escaping from the radiator.

    Wrap a thick cloth around cap. Carefully remove the cap by turning it a quarter turn to allow built-up pressure to escape. Then turn the cap all the way off.

    Check the coolant level in the reservoir tank and radiator.

    Fig 1: Coolant Level In Reservoir Tank
    G04074236Courtesy of NISSAN NORTH AMERICA, INC.

    Allow engine to cool before checking coolant level. 

    Is the coolant level in the reservoir tank and/or radiator below the proper range?

    YES 

    Go to DIAGNOSIS PROCEDURE .

    NO 

    GO TO STEP 2 

  2. PERFORM COMPONENT FUNCTION CHECK-II

    Confirm whether customer filled the coolant or not.

    Did customer fill the coolant?

    YES 

    Go to DIAGNOSIS PROCEDURE .

    NO 

    GO TO STEP 3  .

  3. PERFORM COMPONENT FUNCTION CHECK-III

    G-20With CONSULT 

    1. Turn ignition switch ON.
    2. Perform "COOLING FAN" in "ACTIVE TEST" mode with CONSULT and touch "LOW" on the CONSULT screen.
    3. Make sure that cooling fan operates at low speed.

    G-21Without CONSULT 

    1. Start engine and let it idle.
    2. Turn air conditioner switch and blower fan switch ON.
    3. Make sure that cooling fan operates at low speed.

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    Go to DIAGNOSIS PROCEDURE .

  4. PERFORM COMPONENT FUNCTION CHECK-IV

    G-20With CONSULT 

    1. Touch "HI" on the CONSULT screen.
    2. Make sure that cooling fan operates at higher speed than low speed.

    G-21Without CONSULT 

    1. Turn ignition switch OFF.
    2. Turn air conditioner switch and blower fan switch OFF.
    3. Disconnect engine coolant temperature sensor harness connector.
    4. Connect 150Ω resistor to engine coolant temperature sensor harness connector.
    5. Restart engine and make sure that cooling fan operates at higher speed than low speed.

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Go to DIAGNOSIS PROCEDURE .

scientia non olet · About LEMON Manuals