Physical Values

Terminal	Wire color	Circuit	Input/ Output	Ignition switch	Condition	Value
1	R	Battery power supply	Input	OFF	-	Battery voltage
2	Y	Battery power supply	Input	OFF	-	Battery voltage
3	SB1 W2	Ignition switch power supply (START)	Input	OFF ACC ON	-	0V
				START	-	Battery voltage
5	Y	Cooling fan power supply (HIGH)	Output	ON or START	Cooling fan OFF	0V
					Cooling fan LO	4 - 8 V
					Cooling fan MID or HI	Battery voltage
6	R	Starter motor power supply	Output	OFF ACC ON	-	0V
				START	-	Battery voltage
7	P	Cooling fan power supply (LOW)	Output	ON or START	Cooling fan OFF	0V
					Cooling fan LO	Battery voltage
					Cooling fan MID	4 - 8 V
					Cooling fan HI	Battery voltage
8	G	Battery power supply	Input	OFF	-	Battery voltage
9	BR	Fuel pump power supply	Output	ON RUN	Approximately 1 second after turning the ignition switch ON	Battery voltage
				ON	Approximately 1 second after turning the ignition switch ON	0V
102	L	Ignition switch power supply (ON or START)	Input	OFF		0V
				ON or START		Battery voltage
11	G	ECM relay power supply	Output	OFF	More than a few seconds after turning ignition switch OFF	0V
				ON OFF	For a few seconds after turning ignition switch OFF	Battery voltage
133	R1 LG2	Starter relay coil power supply	Input	ON	Clutch pedal depressed	0V
					Clutch pedal released	Battery voltage
14	L	Headlamp LOW (LH) power supply	Output		Lighting switch OFF	0V
					Lighting switch 2ND	Battery voltage
151 , 3	LG	Starter relay coil power supply	Input			0V
						Battery voltage
16	P	Headlamp LOW (RH) power supply	Output		Lighting switch OFF	0V
					Lighting switch 2ND	Battery voltage
17	LG	Front wiper motor LOW power supply	Output	ON	Front wiper switch OFF	0V
					Front wiper switch LO	Battery voltage
18	GR	Front wiper motor HIGH power supply	Output	ON	Front wiper switch OFF	0V
					Front wiper switch HI	Battery voltage
19	B	Ground	-	-	-	-
20	BR	ABS actuator and electric unit (control unit) power supply	Output	OFF	-	0V
				ON or START	-	Battery voltage
213	G	Clutch interlock switch power supply	Output	OFF or ACC		0V
				ON		Battery voltage
214	R	Transmission range switch power supply	Output	OFF or ACC		0V
				ON		Battery voltage
22	P	Illumination power supply	Output		Lighting switch OFF	0V
					Lighting switch 1ST	Battery voltage
23	R	Combination lamp power supply	Output		Lighting switch OFF	0V
					Lighting switch 1ST	Battery voltage
245	W	Daytime running light relay 1 power supply	Output		Lighting switch OFF	0V
					Lighting switch 1ST	Battery voltage
25	G	Headlamp HIGH (LH) power supply	Output		Lighting switch other than HI and PASS	0V
					Lighting switch HI Lighting switch PASS	Battery voltage
27	Y	Headlamp HIGH (RH) power supply	Output		Lighting switch other than HI and PASS	0V
					Lighting switch HI Lighting switch PASS	Battery voltage
28	V	A/C compressor power supply	Output	RUN	A/C switch OFF	0V
					A/C switch ON (A/C compressor is operating)	Battery voltage
29	L/W	Throttle control motor relay power supply	Output	OFF	More than a few seconds after turning ignition switch OFF	0V
				ON OFF	For a few seconds after turning ignition switch OFF	Battery voltage
32	G/W	Throttle control motor relay control	Output	ON → OFF		0V ↓ Battery voltage ↓ 0 V
				ON		0V
34	Y	Ignition coil power supply	Output	OFF or ACC		0V
				ON		Battery voltage
35	BR	NATS antenna amp power supply	Output	OFF		Battery voltage
36	SB	Fuel injector power supply	Output	OFF or ACC		0V
				ON		Battery voltage
39	L	Timing control solenoid valve power supply	Output	OFF	More than a few seconds after turning ignition switch OFF	0V
				ON OFF	For a few seconds after turning ignition switch OFF	Battery voltage
404	BR	Starter relay coil power supply	Input	ON	Select lever in any position other than P or N	0V
					Select lever P or N	Battery voltage
43	GR	Fuel pump relay control	Output	ON RUN	Approximately 1 second after turning the ignition switch ON	0V
				ON	Approximately 1 second or more after turning the ignition switch	Battery voltage
47	R/W	ECM power supply	Output	OFF	More than a few seconds after turning ignition switch OFF	0V
				ON OFF	For a few seconds after turning ignition switch OFF	Battery voltage
48	O	Generator C	Output	OFF or ACC		0V
				ON		Courtesy of NISSAN NORTH AMERICA, INC.
50	P	ECM relay control	Output	OFF	More than a few seconds after turning ignition switch OFF	0V
				ON OFF	For a few seconds after turning ignition switch OFF	Battery voltage
59	Y	Cooling fan relay control	Output		Cooling fan OFF or LO operated	Battery voltage
					Cooling fan MID or HI operated	0V
60	B	Ground	-	-	-	-
61	P	CAN low	Input/Output	-	-	-
62	L	CAN high	Input/Output	-	-	-
65	BR	Cooling fan relay power supply	Output	OFF or ACC		0V
				ON		Battery voltage
695	GR	Daytime running light relay 1 control	Output			Battery voltage
						0V
716	W	Front fog lamp relay control	Output		Front fog lamp switch OFF	Battery voltage
					Front fog lamp switch ON	0V
73	SB	Horn relay control	Output		Horn is not activated	Battery voltage
					Horn is activated	0V
74	V	Front wiper motor stop position	Input	ON	Front wiper stop position	0V
					Any position other than front wiper stop position	Battery voltage
801	R	PNP switch	Input	ON	Selector Lever in P	0V
					Selector lever in any position other than P	Battery voltage
811	SB	Push-button ignition switch	Input	ON	Press the push-button ignition switch	0V
					Release the push button ignition switch	Battery voltage
891	B	Ground	-	-	-	-
901	L	Ignition relay power supply	Input	ON	Ignition switch OFF or ACC	Battery voltage
					Ignition switch ON	0V

¹ : With Intelligent Key system

² : Without Intelligent Key system

³ : With M/T

⁴ : With CVT

⁵ : With daytime running light system

⁶ : With front fog lamps