Diagnosis Procedure
WARNING: This page is about a different car, the 2017 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK FUSE
Check that the following fuses are not blown.
Terminal No. Signal name Fuse No. 40 Ignition signal 29 (10A) Are the fuses blown?
YES
Replace the blown fuse after repairing the affected circuit.
NO
GO TO STEP 2 .
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector M96.
- Check voltage between around view monitor control unit connector M96 and ground.
Around view monitor control unit Ground Condition Voltage
(Approx.)Connector Terminal M96 40 - Ignition switch: ON Battery voltage
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness or connectors.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Check continuity between around view monitor control unit connector M96 and ground.
Around view monitor control unit Ground Continuity Connector Terminal M96 39 - Yes
Is the inspection result normal?
YES
Inspection End.
NO
Repair or replace harness or connectors.