Fail-Safe Control By DTC
BCM performs fail-safe control when any DTC are detected.
| Display contents of CONSULT | Fail - safe | Cancellation |
|---|---|---|
| B2192: ID DISCORD BCM-ECM * | Inhibit setting the vehicle to READY | Erase DTC |
| B2193: CHAIN OF BCM-ECM * | Inhibit setting the vehicle to READY | Erase DTC |
| B2195: ANTI-SCANNING | Inhibit setting the vehicle to READY | Power switch ON → OFF |
| B2196: DONGLE NG | Inhibit setting the vehicle to READY | Erase DTC |
| B2198: IMMOBI ANT NG | Inhibit setting the vehicle to READY | Erase DTC |
| B261E: FUEL MIS CONFIG | Inhibit setting the vehicle to READY | When the VCM status signal is normally received from VCM. |
| B26F1: IGN RELAY OFF STUCK | Inhibit setting the vehicle to READY | When the following conditions are fulfilled
|
| B26F2: IGN RELAY ON STUCK | Inhibit setting the vehicle to READY | When the following conditions are fulfilled
|
| B26F7: LF DRIVER COMMUNICATION | Inhibit setting the vehicle to READY | When inside key antennas function normally |
| U0415: VDC CAN CIRC2 | Inhibit setting the vehicle to READY | When vehicle speed signal (Meter) (CAN) is received normally |
* : "ECM" is indicated on CONSULT display, however this means VCM on this vehicle.