LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2017 >> Maxima S >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Audio, Visual & Navigation System (Around View Monitor System) >> Ecu Diagnosis Information >> Around View Monitor Control Unit >> Fail-Safe
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Around View Monitor Control Unit: Fail-Safe

DTC
Display contents of CONSULT		 Malfunction detection condition Fail-safe condition
U0428: ST ANGLE SENSOR CALIBRATION Neutral position adjustment of steering angle sensor is not complete. Predicted course line is not displayed.
U1000: CAN COMM CIRCUIT When around view monitor control unit cannot transmit/receive CAN communication signal continuously for 2 seconds or more. The following functions are stopped
  • When communication of steering angle sensor signal is not normal:
    1. Predicted course line is not displayed.
    2. MOD (Moving Object Detection) function is stopped.
  • When communication of wheel speed sensor signal, and shift signal is not normal:
    1. Predicted course line is not displayed.
    2. MOD (Moving Object Detection) function is stopped.
  • When communication of sonar control unit is not normal:
    • Sonar indicator displayed in red.
U111A: REAR CAMERA IMAGE SIGNAL No-signal status of rear camera image signal is continued for 500 ms or more while ignition switch is ON. Camera image is not displayed (gray screen display).
U111B: SIDE CAMERA RH IMAGE SIGNAL No-signal status of side camera RH image signal is continued for 500 ms or more while ignition switch is ON.
U111C: FRONT CAMERA IMAGE SIGNAL No-signal status of front camera image signal is continued for 500 ms or more while ignition switch is ON.
U111D: SIDE CAMERA LH IMAGE SIGNAL No-signal status of side camera LH image signal is continued for 500 ms or more while ignition switch is ON.
U1232: ST ANGLE SEN CALIB Neutral position adjustment of steering angle sensor is performed. NG signal from steering angle sensor is received. Predicted course line is not displayed.
U1302: CAMERA POWER VOLT Camera power supply voltage does not satisfy the following conditions for 2 seconds or more when ignition switch is turned ON:
  • When supplemental lighting power supply output is ON: 5.9 - 6.5 V.
  • When OFF: 0 V by camera power supply measurement.
 Camera power output is stopped.
U1304: CAMERA IMAGE CALIB
  • When camera calibration is incomplete.
  • When camera information in around view monitor control unit and information read from camera are not the same.
 Unmatched icon UNMATCH2 display (red) is displayed (applicable for unmatched camera only).
U1305: CONFIG UNFINISH The vehicle setting of around view monitor control unit is incomplete. Operation is according to the vehicle setting value as default value.
scientia non olet · About LEMON Manuals