Diagnostic Test

With CONSULT 

1. Turn ignition switch ON.
2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
3. Check "BRAKE SW1" indication under the following conditions.

   Monitor item	Condition		Indication
   BRAKE SW1 (ICC brake switch)	Brake pedal	Slightly depressed	OFF
   		Fully released	ON

Without CONSULT 

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals.

   ECM			Condition		Voltage
   Connector	+	-
   	Terminal
   E10	140	152	Brake pedal	Slightly depressed	Approx. 0 V
   				Fully released	Battery voltage

Is the inspection result normal?

YES 

INSPECTION END

NO 

Proceed to DIAGNOSIS PROCEDURE .