DTC Detection Logic
This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF.
If ECM judges there are no leaks, the diagnosis will be OK.
- EVAP system has a leak.
- EVAP system does not operate properly.
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0456 | EVAP VERY SML LEAK [Evaporative emission system leak detected (very small leak)] |
1 | Diagnosis condition | - |
| Signal (terminal) | - | |||
| Threshold | EVAP system has a leak | |||
| Diagnosis delay time | - | |||
| 2 | Diagnosis condition | - | ||
| Signal (terminal) | - | |||
| Threshold | EVAP system does not operate properly | |||
| Diagnosis delay time | - | |||
CAUTION:
- Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may come on.
- If the fuel filler cap is not tightened properly, the MIL may come on.
- Use only a genuine NISSAN rubber tube as a replacement.