DTC Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO STEP 2.
- PERFORM DTC CONFIRMATION PROCEDURE-I
- Clear the mixture ratio self-learning value. Refer to DESCRIPTION .
- Start engine.
Is it difficult to start engine?
YES
GO TO STEP 3.
NO
GO TO STEP 4.
- RESTART ENGINE
If it is difficult to start engine, the fuel injection system has a malfunction, too.
Crank engine while depressing accelerator pedal.
NOTE:- When depressing accelerator pedal three-fourths (3/4) or more, the control system does not start the engine. Do not depress accelerator pedal too much.
Does engine start?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO
Check exhaust and intake air leakage visually.
- PERFORM DTC CONFIRMATION PROCEDURE-II
- Keep engine idle for at least 5 minutes.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO
GO TO STEP 5.
- PERFORM DTC CONFIRMATION PROCEDURE-III
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine.
- Maintain the following conditions for at least 10 consecutive minutes.
Hold the accelerator pedal as steady as possible.
VHCL SPEED SE 50 - 120 km/h (31 - 75 mph) CAUTION:Always drive vehicle at a safe speed.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO - 1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO - 2
Confirmation after repair: INSPECTION END