DTC Detection Logic
- The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking.
- The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running.
- The crankshaft position sensor (POS) signal is not in the normal pattern during engine running.
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0335 | CKP SEN/CIRCUIT (Crankshaft position sensor "A" circuit) |
1 | Diagnosis condition | Start engine and let it idle |
| Signal (terminal) | Voltage signal transmitted from crankshaft position sensor (POS) to ECM | |||
| Threshold | The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking | |||
| Diagnosis delay time | - | |||
| 2 | Diagnosis condition | Start engine and let it idle | ||
| Signal (terminal) | Voltage signal transmitted from crankshaft position sensor (POS) to ECM | |||
| Threshold | The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running | |||
| Diagnosis delay time | - | |||
| 3 | Diagnosis condition | Start engine and let it idle | ||
| Signal (terminal) | Voltage signal transmitted from crankshaft position sensor (POS) to ECM | |||
| Threshold | The crankshaft position sensor (POS) signal is not in the normal pattern during engine running | |||
| Diagnosis delay time | - | |||